Help out a newbie here.
I took the new boomstick out for a test run today. I've got maxiball bullets. Tried to load them with a patch, but it wouldn't go down. It was so tight that the starter was leaving an imprint on the top of the bullet as I tried to get it to go down, and the cotton was actually getting cut in a few places at the bottom of the bullet. They went in without a patch, but I had no accuracy, which I think is because I don't have the seal that a patch is supposed to give. The patches I've got are the pre-lubed cotton, .005 inch thick. I'm using .50 cal maxiball lead cast bullets. This is a brand new gun, the barrel is fine, and right now I'm assuming that any and all problems with accuracy are caused by operator headspace and timing.
Any ideas?
No comments:
Post a Comment
Comments are moderated. If you do not see your comment immediately, wait until I get home from work.
Note: Only a member of this blog may post a comment.